Project Name: Servo with analog input

Aim of the project:  How to Program a Servo With Arduino an control using Potentiometer

Component:

  • Arduino
  • Servo
  • Potentiometer
  • Jumper Wire

Circuit Diagram:

Code:

#include <Servo.h>
   Servo myservo; // create servo object to control a servo
   int potpin = 0; // analog pin used to connect the potentiometer
   int val; // variable to read the value from the analog pin

void setup() {
   myservo.attach(9); // attaches the servo on pin 9 to the servo object
}

void loop() {
   val = analogRead(potpin);
   // reads the value of the potentiometer (value between 0 and 1023)
   val = map(val, 0, 1023, 0, 180);
   // scale it to use it with the servo (value between 0 and 180)
   myservo.write(val); // sets the servo position according to the scaled value
   delay(15);
}

Runs Steps: